Work on occupied buildings is planned around tenants: noise, parking, access and hours are discussed before the crew arrives. Each roofer has his own approach to this. Call the number on this page to be connected with a local roofing contractor in Redmond.

Common commercial roof systems
- Modified bitumen (torch-down and cold-applied)
- TPO and other single-ply membranes
- Built-up roofs with gravel or coating
- Metal panels on warehouses and shops
Each has its own repair methods. Ask the roofer which system is on your building, how long each repair should hold up and what upkeep it needs.
Phasing the work
Large roofs are often done in sections so that part of the building stays covered and usable. Phasing can protect inventory and tenants, though it can lengthen the schedule. Ask how sections will be sealed at the end of each day. Ask how the roofer handles sections left open overnight.
Older buildings dating to the 1980s commonly have patched flat roofs, so a thorough condition report helps managers plan repair or replacement.
Permits and approvals
Many reroofing projects need a building permit, and some jurisdictions have rules on insulation or energy performance. Associations and landlords may need board or owner approval. A roofer or the local permit office can explain what applies. Ask the roofer who applies for the permit and who pays for it.
Metal roofs on shops and warehouses
Metal panels fail at fasteners, seams and flashings rather than across the panel. Rust, loose screws and failed sealant cause most leaks. A roofer may reseal, replace fasteners or coat the roof, depending on its condition. Ask the roofer to check fasteners and ridge seams first.
Do not send staff onto the roof
Maintenance workers sometimes climb up to clear a drain or look at a leak. Wet membranes are slippery, edges may be unprotected and unseen skylights or soft spots are dangerous. Leave roof work to trained roofers. Ask the roofer to bring proper fall protection for roof access.
Roof notes for Redmond
Reroof permits for Redmond addresses go through the City of Redmond permit office. Its published rule: residential work exempt from permit includes light weight roof covering (composition, metal or similar) where installed unit weight is less than 4 pounds per square foot.
Washington L&I registers construction contractors. Its free lookup shows whether a roofer's registration is active and whether there are claims against it.
Months of steady rain, shaded roofs and mild temperatures make moss and debris a constant here. Gentle removal is better for shingles than a pressure washer.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Much of the housing in Redmond dates to the 1980s or earlier, so a tear-off can uncover older layers or board decking that need extra work.
Calls from Redmond are often matched with roofers who also cover Kirkland, Bellevue and Woodinville.
Redmond at a glance
Calls come in from across Redmond, including around Overlake, Education Hill, Redmond Town Center.
Downtown Redmond sits just north of Lake Sammamish with the Sammamish River along its west edge.
Commercial Roofing questions in Redmond
Can roofing continue while the building is open?
What is a maintenance program for a commercial roof?
Do manufacturer warranties matter?
How do I check a roofer is registered in Washington?
More roofing services in Redmond
Commercial Roofing nearby
Helpful guides
Sources
Last updated: