Rain on metal can sound louder than on shingles, but solid decking, underlayment and attic insulation absorb most of it. Most owners find it comfortable and even pleasant. Call the number on this page to be connected with a local roofing contractor in Redmond.

Common metal roof styles
- Standing seam with raised ribs
- Corrugated or ribbed panels
- Metal shingles and shakes
- Flat-lock and batten-seam profiles
A roofer can show samples and explain which suit your home's architecture and pitch. Ask the roofer for samples, a profile drawing and a recent install photo of each style.
Thermal movement and fasteners
Metal expands and contracts through daily and seasonal temperature swings. Concealed clips let standing seam move freely, while screws in exposed-fastener roofs can back out and need checking. Ask how movement is accommodated and what maintenance the roof will need. Ask about periodic maintenance visits.
Older Redmond homes from the 1980s often have several shingle layers, so the roofer should decide between tear-off and a batten overlay.
Snow guards, vents and accessories
Plan ahead for snow retention, ridge vents, pipe boots and gutters. Many are specific to the panel profile and must be ordered with the roof. Late changes can mean cutting finished panels, which risks leaks and voided finish warranties. Ask about each item before signing.
Comparing metal quotes
Confirm each quote names the same panel profile, gauge, finish, underlayment and trim. Ask about tear-off, snow guards and gutters. A bid that leaves those out may look attractive but can lead to costly change orders after work begins. Ask for revised pricing in writing.
If you hear dripping or banging
Dripping may be condensation or a leak at flashing. Banging in wind can mean loose trim or panel. Check from the ground, photograph what you see and note when sounds occur. Describe it to the roofer without climbing onto slick metal. Do not climb up to look.
Permits, weather and roofs in Redmond
On permits, the City of Redmond permit office says: residential work exempt from permit includes light weight roof covering (composition, metal or similar) where installed unit weight is less than 4 pounds per square foot.
A quick check that pays off: enter the contractor's name in L&I's online verify tool to confirm an active Washington registration.
Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Much of the housing in Redmond dates to the 1980s or earlier, so a tear-off can uncover older layers or board decking that need extra work.
Nearby, the same kind of help is available in Kirkland, Bellevue and Woodinville.
More about Redmond
Calls come in from across Redmond, including around Overlake, Education Hill, Redmond Town Center.
Downtown Redmond sits just north of Lake Sammamish with the Sammamish River along its west edge.
Metal Roofing questions in Redmond
Can metal roofing go over my existing shingles?
Do I need snow guards in Washington?
What metal is best near salt water?
Does a metal roof need a permit?
More roofing services in Redmond
Metal Roofing nearby
Helpful guides
Sources
Last updated: