Ridge vents can improve exhaust airflow, but only when matching intake exists and the existing vents are not working against them. Mixing vent types is a common mistake that a roofer will look for. Cost and design depend on the roof shape and attic layout in this area. Call the number on this page to be connected with a local roofing contractor in Redmond.

Clues from outside the house
Look from the yard at the ridge and the eaves. Missing or painted-over soffit vents, a ridge with no opening, ice or damp streaks below roof edges after a cold snap, and moss on one slope can all hint at airflow problems inside. Take note of what you see.
Wet climate, extra moisture
Cool, damp months mean indoor humidity has little chance to escape outdoors, and attics stay saturated far longer than in dry regions. Cooking, laundry, crawlspace moisture and drying clothes indoors all add water that will find the attic. Indoor moisture from showers, laundry and cooking adds up quickly.
With homes from the 1980s common in Redmond, original attic layouts may lack baffles and balanced vents, and later insulation often covers whatever intake existed.
Fan ducting adds to the scope
Moving a bathroom fan from the attic to the outside means new duct, a roof or wall cap, and sealing around the opening. Access, run length and attic space all change the cost. Ask whether the work includes insulating the duct. Attic layout affects both.
Ridge vents explained
A ridge vent is a continuous opening along the peak covered by a vent cap. It works well when soffits supply air and nothing else competes with it. Ask whether your roof framing supports it and how it will handle wind-driven rain. Wind-driven rain and snow should be addressed.
Avoid unsafe attic work
Step only on joists or boards, and avoid hot summer afternoons. Wear a dust mask around old insulation or visible mold. If you are not comfortable, simply look from the hatch and let a professional handle the rest. Tell the roofer what you saw, and when you saw it.
Before you call in Redmond
Permit note from the City of Redmond permit office: Residential work exempt from permit includes light weight roof covering (composition, metal or similar) where installed unit weight is less than 4 pounds per square foot.
Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.
Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Much of the housing in Redmond dates to the 1980s or earlier, so a tear-off can uncover older layers or board decking that need extra work.
Calls from Redmond are often matched with roofers who also cover Kirkland, Bellevue and Woodinville.
Redmond at a glance
Calls come in from across Redmond, including around Overlake, Education Hill, Redmond Town Center.
Downtown Redmond sits just north of Lake Sammamish with the Sammamish River along its west edge.
Roof Ventilation questions in Redmond
What causes condensation in an attic?
Why is my attic hot in summer?
Should I use a dehumidifier in the attic?
What does a ventilation inspection involve?
More roofing services in Redmond
Roof Ventilation nearby
Helpful guides
Sources
Last updated: