Flat roof repair fixes seams, flashing, punctures and ponding on low-slope roofs such as torch-down, TPO and rubber membranes. Seattle's long rainy season exposes small defects quickly. Call the number on this page to be connected with a local roofing contractor in Seattle.

What flat roof repair involves
Low-slope roofs are not truly flat. They drain slowly toward scuppers, drains or edges, so water lingers longer than on a pitched roof. Repairs usually mean patching a seam or blister, resealing flashing at walls and vents, clearing drains and replacing a failed section of membrane. Common coverings are torch-down, TPO and similar single-ply sheets, and a roofer needs to know which you have before choosing materials.
Signs of trouble
From the ground, from a window or an upper floor, look for these.
- Standing water that remains a day or more after rain stops
- Stains on a ceiling below, often near walls or around vents
- Bubbles, cracks, split seams or peeling edges in the membrane
- Debris, fir needles or moss packing the drains
Do not walk the roof to check. A wet membrane is slick, and many low-slope roofs have edges with no guard. Put a bucket under any drip, move valuables and take photographs.
Why Seattle roofs struggle
NWS describes the Sea-Tac rainy season as October through March, so a small leak runs for months before summer. Tree canopy drops needles and leaves that clog drains, and moss and mud settle on shaded low-slope sections. Flat and low-slope sections are common on Seattle's mid-century homes, additions, garages and small commercial buildings.
What happens on the call and the visit
Say what the roof is made of if you know, where the water shows up inside and how old the roof is. The roofer should trace the leak to its source rather than patch where the stain is. Ask for the scope in writing, including whether the work is a repair or a partial replacement, what flashing is being redone and how drainage will be handled.
What it costs
HomeGuide, a national guide, lists torch-down repair at roughly $2.50 to $10 per square foot, and TPO flashing repair at about $200 to $500 per job. RoofingCalc's King County figure for a full PVC membrane replacement is about $8.50 to $14.50 per square foot. These are cost guides rather than quotes.
Washington roofers must be registered with L&I, so check the contractor on Verify a Contractor before agreeing to work. Replacing roof cover on commercial and multifamily buildings needs a Seattle re-roof permit, so ask who handles it.
Flat Roof Repair questions from Seattle homeowners
How do I know if my flat roof can be repaired?
Is standing water on a low-slope roof a problem?
What do flat roof repairs cost?
Can I patch a flat roof myself?
Related roofing services in Seattle
Helpful guides
Flat Roof Repair in nearby cities and towns
King County
Snohomish County
Pierce County
Kitsap County
Island County
Mason County
Jefferson County
Sources
Last updated: