Chimney flashing has two parts: step pieces layered with the shingles and counter-flashing set into the masonry above them. Failure of either one lets water behind the brick. Call the number on this page to be connected with a local roofing contractor in Kingston.

Clues from the attic
- Dark staining on decking around the chimney
- Rust streaks or drip trails on the brick surface
- Damp insulation beside the framing
- Daylight visible between brick and roof deck
A flashlight check reveals plenty without leaving the attic hatch.
Past repairs that backfired
Heavy tar and roofing cement over a chimney joint can look solid for a season, then crack and trap water against the brick. Painted-over sealant also hides cracks. Roofers often have to remove old patchwork before a lasting repair can go on.
Under heavy tree cover, the uphill side of a chimney becomes a debris trap, so a cricket and regular cleaning can make a real difference.
Near the water, salt speeds rust on thin metal around a chimney, so flashing can fail sooner than it would inland.
Reflash with a reroof
If the roof is near replacement, redoing chimney flashing at the same time makes sense, since it can tie directly into new shingles. Ask the roofer to price the chimney as its own line, so you can compare patching now with doing it later.
What the roofer inspects
Expect a close look at the base flashing, counter-flashing, mortar lines, cricket, nearby shingles and the attic. A roofer should show where the water is getting in and say whether the masonry needs a mason. Ask for photos of any problem areas.
Loose brick or leaning stack
Bricks that have shifted, a visible lean or chunks falling from the top are safety issues. Keep people and pets away from the area below and call promptly. A mason and a roofer may both be needed, and a fall risk is more urgent than a drip.
Useful local facts for Kingston
On permits, the Kitsap DCD says: roofing permit required for residential if it includes structural work or more than 2,100 square feet of roofing materials are being replaced; always required for commercial.
Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.
Homes near the water around Kingston take more wind and salt exposure, which wears metal flashing and fasteners faster.
Months of steady rain, shaded roofs and mild temperatures make moss and debris a constant here. Gentle removal is better for shingles than a pressure washer.
Tall evergreens around Kingston drop needles that fill valleys and gutters and keep roofs shaded and damp, which is where moss starts.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Calls from Kingston are often matched with roofers who also cover Edmonds, Indianola and Suquamish.
Chimney Flashing Repair questions in Kingston
Why does my chimney leak where it meets the roof?
What is a chimney cricket?
Do I need a mason or a roofer?
How often should chimney flashing be checked?
More roofing services in Kingston
Chimney Flashing Repair nearby
Helpful guides
Sources
Last updated: