Wide chimneys often need a small peaked structure behind them, called a cricket or saddle, to shed water around the brick. Without one, debris and water pool uphill. Call the number on this page to be connected with a local roofing contractor in Des Moines.

Looking from the ground
With binoculars, check for gaps between the metal and the brick, bright or flaking rust, tar smears around the base and cracked caulk lines. Missing or crumbling mortar high on the stack shows up too. Take photos so the roofer can plan.
Mortar, cap and crown trouble
- Crumbling mortar joints that soak up rain
- Cracked crown, the concrete slab on top
- Missing or rusted chimney cap
- Spalling brick faces flaking off
These need a mason, and fixing flashing alone will not stop them.
Homes from the 1970s in Des Moines often have unlined or well-worn chimneys, so a roofer may suggest a chimney professional look at the stack alongside the flashing work.
Near the water, salt speeds rust on thin metal around a chimney, so flashing can fail sooner than it would inland.
Questions that affect the quote
- How wide is the chimney, and how tall above the roof?
- What is the roof pitch and shingle type?
- Is the mortar sound or crumbling?
- Is there a cricket already?
- Has it been sealed before?
Before you call in Des Moines
If the job grows from a patch into a full reroof or framing repair, check with the City of Des Moines permit office before work starts.
Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.
Homes near the water around Des Moines take more wind and salt exposure, which wears metal flashing and fasteners faster.
Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Much of the housing in Des Moines dates to the 1970s or earlier, so a tear-off can uncover older layers or board decking that need extra work.
Calls from Des Moines are often matched with roofers who also cover SeaTac, Kent and Federal Way.
Coordinating a roofer and a mason
When both are needed, order matters. Masonry repairs usually come first, so new flashing is set into sound mortar. Tell each trade about the other, share written findings and schedule them close together to limit the time the chimney stays exposed.
Protect the attic
If you can reach the attic safely, move stored items away from the chimney framing and lay plastic over wet insulation without stepping between joists. Wet insulation and framing may need drying, so mention what you see.
Chimney Flashing Repair questions in Des Moines
Why does my chimney leak where it meets the roof?
Do I need a mason or a roofer?
Does this service charge me for the call?
Should I use my fireplace if the chimney leaks?
More roofing services in Des Moines
Chimney Flashing Repair nearby
Helpful guides
Sources
Last updated: