Roofing referrals for Seattle & nearby townsCall: (206) 984-7830
(206) 984-7830

Torch-Down Roofing in University Place, WA

roofingseattle.net

If your flat roof in University Place is a rolled bitumen surface that is aging, talk to an independent roofer about the options.

Torch-down roof wearing out in University Place?
Call now to be connected with a local roofing contractor in University Place.
(206) 984-7830

Torch-down roofing is modified bitumen sheet that a roofer bonds to the roof by heating the underside with a propane torch. It is built in layers, with a cap sheet on top. Call the number on this page to be connected with a local roofing contractor in University Place.

Roofers unroll modified bitumen roofing on a flat roof with safety equipment staged nearby, torch-down roofing in University Place, WA

What torch-down roofing actually is

Torch-down is a roll roofing made of asphalt modified with plastic or rubber and reinforced with fabric. A roofer unrolls the sheet and heats its underside so it fuses to the layer below. The result is a continuous, waterproof surface with few joints. It handles long wet seasons well.

Fire-safety steps roofers take

  • Fire extinguishers kept on the roof
  • Clearing leaves and debris from the work area
  • Shielding vents, walls and gaps near the flame
  • Checking that gas hoses and cylinders are secure

Careful roofers treat these as routine. Never try work near a gas line or a vent.

Salt spray speeds corrosion of fasteners and drip edges around a bitumen roof, so ask the roofer what metals and finishes he plans to use.

Call now to be connected with a local roofing contractor in University Place.
(206) 984-7830

Sun, shade and granule wear

Granules protect the asphalt from sunlight and water flow carries them away over time. Shaded sections stay damp and grow moss, while sunny sections dry and harden. When bare asphalt shows through, the roof is aging fast. Photos of bare patches are useful when you call.

Scheduling around rain

Torch-applied membranes need a dry surface and calm conditions. Rainy weeks can push a start date back, and the schedule may shift after work begins. Ask how the roofer handles weather delays and temporary protection. Plan around possible delays, and ask what protects the roof between visits.

What a visit usually covers

The roofer examines the surface, laps, flashings, drains and edges, and may probe suspect spots. Expect questions about leak history and past repairs. A clear written scope and photos of the problem areas should follow. Ask to see any warranty in writing and read what it covers and excludes.

Roof notes for University Place

If the job grows from a patch into a full reroof or framing repair, check with the City of University Place permit office before work starts.

Washington L&I registers construction contractors. Its free lookup shows whether a roofer's registration is active and whether there are claims against it.

Homes near the water around University Place take more wind and salt exposure, which wears metal flashing and fasteners faster.

Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.

Storm took out power too? Report it to Tacoma Power at 253-502-8602, and stay clear of any downed line.

Before you call, note how many stories the house is and snap photos of the problem spots from the ground. It helps the roofer plan ladders and materials.

Calls from University Place are often matched with roofers who also cover Lakewood, Tacoma and Fox Island.

Torch-Down Roofing questions in University Place

Is torch-down roofing safe?
It can be when installed by trained roofers who follow fire-safety practices, such as keeping extinguishers on the roof and checking for hidden heat afterward. It is not safe as a do-it-yourself job.
Does torch-down roofing need a permit?
Rules differ by city and county, and some jurisdictions have requirements for reroofing or for the flame work itself. A roofer or the local permit office can tell you what applies.
What should I do if I smell smoke during roofing work?
Call 911 right away, get everyone out and tell the crew. Smoke from a hidden smolder can appear after the torch is off, so do not wait to see whether it passes.
How do I check a roofer is registered in Washington?
Washington requires roofing contractors to register with L&I, and the business registration can be looked up online. Confirm it is active before you agree to any work.

More roofing services in University Place

Torch-Down Roofing nearby

Call now to be connected with a local roofing contractor in University Place.
(206) 984-7830

Last updated:

☎ Call (206) 984-7830