Roofing referrals for Seattle & nearby townsCall: (206) 984-7830
(206) 984-7830

Chimney Flashing Repair in Lakewood, WA

roofingseattle.net

From a wide chimney needing a cricket to a simple flashing swap, local roofers handle the roof side for your Lakewood house.

Ready for a roofer to check your Lakewood chimney?
Call now to be connected with a local roofing contractor in Lakewood.
(206) 984-7830

Water near a chimney can come from the flashing, the mortar joints, the cap or the crown, so the cause needs confirming before anything is replaced. A roofer can narrow it down. Call the number on this page to be connected with a local roofing contractor in Lakewood.

A brick chimney with new metal flashing installed on a shingled roof, chimney flashing repair in Lakewood, WA

Gaps that widen with age

Brick, mortar and wood move at different rates with moisture and temperature. Over time that movement opens a thin gap along the flashing line. A hairline separation today often becomes a steady drip in a wet winter, so early attention pays off.

How chimney flashing is built

The base of the chimney is wrapped in layers. Step flashing goes up the sides, a front apron lies under the shingles, and counter-flashing is tucked into cut mortar joints above to cover the top edge. Each layer depends on the others for protection.

Call now to be connected with a local roofing contractor in Lakewood.
(206) 984-7830

Questions that affect the quote

  • How wide is the chimney, and how tall above the roof?
  • What is the roof pitch and shingle type?
  • Is the mortar sound or crumbling?
  • Is there a cricket already?
  • Has it been sealed before?

Why sealant is a stopgap

Caulk along the brick face gives a few quiet months, then splits as the masonry moves. It is fine as a temporary measure when the weather is bad, but it should not replace the layered flashing. Be skeptical of a one-bead fix.

Permits, weather and roofs in Lakewood

If the job grows from a patch into a full reroof or framing repair, check with the City of Lakewood permit office before work starts.

A quick check that pays off: enter the contractor's name in L&I's online verify tool to confirm an active Washington registration.

Fall and winter windstorms are the main source of sudden roof damage around Puget Sound. Lifted tabs and loose ridge caps are worth a look after a blow.

Storm took out power too? Report it to Tacoma Power at 253-502-8602, and stay clear of any downed line.

Before you call, note how many stories the house is and snap photos of the problem spots from the ground. It helps the roofer plan ladders and materials.

Nearby, the same kind of help is available in University Place, Tacoma and Fox Island.

Contain the water

Put a bucket beneath any drip, move furniture and rugs aside and keep the fireplace area clear. Photograph the stain with the date. If a ceiling bulges, stay out from under it and call quickly. Water near light fixtures is a hazard.

Chimney Flashing Repair questions in Lakewood

Why does my chimney leak where it meets the roof?
Brick and wood move at different rates, so the joint between them opens over time. Rusted flashing, dried sealant and a missing cricket are the usual causes.
Do I need a mason or a roofer?
Often both. A roofer handles flashing, shingles and a cricket, and a mason repairs brick, mortar and crowns. A roofer can say which applies.
How are repair prices decided?
Each independent roofer sets its own price based on chimney size, roof pitch, access and what is damaged. This referral service does not set or quote prices.
Can chimney flashing be fixed without replacing the roof?
Usually yes. If the shingles are sound, a roofer can reflash the chimney and tie it into the existing roof.

More roofing services in Lakewood

Chimney Flashing Repair nearby

Call now to be connected with a local roofing contractor in Lakewood.
(206) 984-7830

Last updated:

☎ Call (206) 984-7830