Metal panels are made from steel or aluminum with factory finishes, and coastal homes may need aluminum or specific coatings to resist salt air. A roofer can recommend suitable products. Call the number on this page to be connected with a local roofing contractor in Kenmore.

Metal that looks like shingles or cedar
Stamped metal shingles and shakes give the look of traditional roofing with the shedding performance of metal. They interlock in smaller pieces and suit homes where a plain panel would look out of place. Ask about weight, edge details and how repairs are handled. Ask who installs them, too.
Walking and maintenance
Metal can be very slippery when wet, so homeowners should never walk on it. Roofers use appropriate gear and walk on specific areas of panels. Annual checks focus on sealants, fasteners and flashing, and washing with a soft brush keeps the finish clean. Ask which cleaners are safe for the finish.
Shaded, wooded lots grow moss quickly on shingles, which is why many owners nearby look at metal, and a roofer can advise on finish and trimming.
Before you call in Kenmore
If the job grows from a patch into a full reroof or framing repair, check with the Kenmore Development Services before work starts.
Washington requires roofing contractors to register with the Department of Labor & Industries. L&I's Verify a Contractor tool shows a company's registration status before you sign anything.
Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.
Tall evergreens around Kenmore drop needles that fill valleys and gutters and keep roofs shaded and damp, which is where moss starts.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Find the age of the roof if you can (closing papers or old receipts help) and note where any water shows up inside.
Nearby, the same kind of help is available in Mountlake Terrace, Bothell and Shoreline.
Permits and plan review
A conversion may require a permit, especially if the load, deck or fastening changes. Metal weighs less than tile but may differ from existing roofing. Ask the roofer who pulls the permit and what documents the building office expects. Keep copies of approved drawings on file.
Standing seam versus exposed fastener
Concealed-fastener standing seam typically costs noticeably more than ribbed panels screwed through the face. The gap buys cleaner looks, fewer penetrations and less maintenance. For outbuildings and budget projects, exposed-fastener panels can be a reasonable compromise if screws are checked periodically. The difference shows mostly in upkeep.
After installation
Walk the roof lines from the ground and check trim, ridge, valleys and snow guards. Keep the contract, finish and material warranty papers, paint codes and permit sign-off. Future repairs and touch-ups are easier when the exact panel and color are on record. Take dated photos while the work is fresh.
Metal Roofing questions in Kenmore
Do I need snow guards in Washington?
What metal is best near salt water?
Will metal roofing hurt my property value or insurance?
Does metal roofing work near tall trees?
More roofing services in Kenmore
Metal Roofing nearby
Helpful guides
Sources
Last updated: