Price depends on membrane thickness, how it is attached, the insulation below, the flashing detail and how reachable the roof is. Each independent roofer sets his own price. Call the number on this page to be connected with a local roofing contractor in Fife.

How a TPO roof is built
Below the membrane sits insulation board and a sound deck. The sheet is either fastened through the insulation, glued down or held in place with ballast. Edge metal and flashings finish the perimeter, and each piece must match the rest. Ask which method suits your deck.
Mechanical fasteners and plates
On fastened systems, screws and plates hold the sheet to the deck. Backed-out fasteners can lift the membrane and create wear spots. A roofer checks them during an inspection and reseats any that have loosened. Backed-out fasteners are an easy repair when caught early, so mention any you see.
Permits, weather and roofs in Fife
If the job grows from a patch into a full reroof or framing repair, check with the City of Fife permit office before work starts.
Before work begins, look the company up on L&I's Verify a Contractor page. Washington requires construction contractors, roofers included, to be registered.
Fall and winter windstorms are the main source of sudden roof damage around Puget Sound. Lifted tabs and loose ridge caps are worth a look after a blow.
Storm took out power too? Report it to Tacoma Power at 253-502-8602, and stay clear of any downed line.
If the damage came from a storm, write down the date and keep your photos; you may want them for an insurance claim.
Contractors that take calls here usually also work in Tacoma, Milton and Pacific.
Tear-off or recover
A new TPO sheet can sometimes go over an older roof if it is dry and sound. If the old layers hold moisture, the roofer may recommend a tear-off. That choice changes disposal, labor and timing quite a bit. Ask the roofer to show you moisture readings that support the recommendation.
Moss, algae and debris on a white roof
Shaded sections can grow algae and collect needles and leaves. Gentle cleaning and drain care keep the membrane in good shape. Harsh pressure or scrapers can scar the surface, so ask the roofer how to clean it. Pressure washers can damage welds and flashings, so avoid them.
What the inspection visit covers
The roofer looks at the membrane, welds, flashings, drains, edges and any ponding, and may probe suspect areas. Expect questions about leaks, past repairs and building use. A written scope with photos should follow. Ask the roofer to explain any gaps in the scope before you agree.
TPO Roofing questions in Fife
Why is TPO usually white?
How long does a TPO roof last?
What is the difference between TPO and torch-down?
How do I check a roofer is registered in Washington?
More roofing services in Fife
TPO Roofing nearby
Helpful guides
Sources
Last updated: