Goopy sealant smeared over a joint is a sign of past trouble, not a lasting fix. Proper repair rebuilds the metal and shingle layering. Call the number on this page to be connected with a local roofing contractor in Bremerton.

Flashing versus worn shingles
Worn shingles leak across a wide area, with granules in the gutters and curling edges. Flashing leaks happen at a single detail, often with an otherwise healthy roof around it. Telling the two apart is the first job of a good roofer.
Wall and headwall flashing
Where a roof runs into the front of a wall, such as above a dormer or an addition, a continuous piece of flashing is covered by siding or counter-flashing above. If the siding is tight or caulked wrongly, water can slip behind it and reach the sheathing.
Exposed bluff and shoreline roofs take stronger gusts that lift loose flashing edges, so secure fastening matters, as does a periodic check after big storms.
Rotted decking changes the job
If water has leaked for a long time, the plywood under the flashing may be soft. Replacing a section of decking adds labor and material to the repair. Ask the roofer to explain what they find and to show you photos before agreeing to extra work.
Before you call in Bremerton
Permit note from the Bremerton DCD: The City of Bremerton exempts single-family residential re-roofs provided that the roof is less than 4,000 square feet and only the roofing material (i.e., shingles) is replaced with no structural changes.
Washington requires roofing contractors to register with the Department of Labor & Industries. L&I's Verify a Contractor tool shows a company's registration status before you sign anything.
Homes near the water around Bremerton take more wind and salt exposure, which wears metal flashing and fasteners faster.
Most roof trouble in this part of Washington shows up in the wet season, when a small gap in flashing or a lifted shingle has months of rain to work on.
Storm took out power too? Report it to PSE at 888-225-5773, and stay clear of any downed line.
Nearby, the same kind of help is available in Port Orchard, Seabeck and Belfair.
Why sealant alone fails
Caulk and roofing cement fill gaps but do not provide the overlap that sheds water. They shrink, crack and trap moisture. A roofer who offers only sealant at a failed joint should explain how water will be directed away afterward.
Stay off the roof
- Wet roofs and moss are extremely slippery
- Metal flashing edges are sharp
- Wind makes ladders unsafe
- Roofing cement spread from a ladder rarely lasts
Observe from the ground or an attic window, then let a roofer handle the climb.
More about Bremerton
Calls come in from across Bremerton, including around Downtown Bremerton, East Bremerton, Manette.
Bremerton gets noticeably more rain than Seattle, with wet, mild winters and occasional light snow.
Roof Flashing Repair questions in Bremerton
Can flashing be damaged by moss removal?
Is it safe to climb up and check flashing myself?
Can new flashing match the old?
My home is near the water. Does that change anything?
More roofing services in Bremerton
Roof Flashing Repair nearby
Helpful guides
Sources
Last updated: